How do I enable/disable my Iptables firewall?

To start IP tables on your RedHat server,
# service iptables start

You can run the following command to stop iptabes:
# service iptables stop

It is also important to save your iptables configuration so that it is loaded again on the next reboot. This can be done by running:

# service iptables save

You can also set the iptables program to start on boot by running:
# chkconfig iptables on

  • 896 Kasutajad peavad seda kasulikuks
Kas see vastus oli kasulik?

Seotud artiklid

Can I load balance servers that are behind a firewall?

Yes, in proxy mode your servers can live anywhere and as long as you can get to the real port you...

Hardware Firewall configuration

A Hardware Firewall is a network device that is connected upstream from a server. The Firewall...

Ranges to allow through server firewall

Frontend (public) network:Ports to allow:ICMP – ping (for support troubleshooting)All...

Configure APF Firewall

A firewall is a very good idea for a server. Though many people think that a firewall is...

How to install APF (Advanced Policy Firewall)

What is APF (Advanced Policy Firewall)? APF FirewallAPF is a policy based iptables firewall...